| After-sales Service: | Online |
|---|---|
| Warranty: | 10 Months |
| Customized: | Non-Customized |
| Standard Component: | Standard Component |
| Type: | Laser Control Card |
| Transport Package: | Carton |
| Customization: |
|---|
Suppliers with verified business licenses
Audited Supplier 
In this picture above:| CON4 pins | Name | function |
| 4, 5 | VCC | +5V power supply |
| 11, 12, 13 | GND | Reference ground of the power supply. |
| Pin | Name | Function |
| 1, 9 | CLK- / CLK+ | Clock signal- / Clock signal+ |
| 2,10 | SYNC- / SYNC+ | Synchronization signal - / Synchronization signal+ |
| 3, 11 | X Channel- / X Channel+ | Scanhead signal X- / Scanhead signal X+ |
| 4, 12 | Y Channel- / Y Channel+ | Scanhead signal Y- / Scanhead signal Y+ |
| 5, 13 | Z Channel- / Z Channel+ | Scanhead signal Z- / Scanhead signal Z+ |
| 6, 14 | Status-/Status+ | Reserved |
| 7 | NULL | Reserved |
| 8, 15 | GND | Reference signal |
| Pin No. | Signal | Illustration |
| 1 - 8 | P0 - P7 | Laser power signal.TTL compatible |
| 9 | PLATCH | Power signal latch. TTL compatible. |
| 10, 14, | GND | The reference ground of the control board. |
| 11,12,16,21 | LASERST0~3 | Alarm signal of Laser module |
| 17 | VCC | 5V power output. |
| 18 | MO | Main oscillator signal. TTL compatible. |
| 19 | AP | Power amplifier signal. TTL compatible. |
| 20 | PRR | Pulse repetitive rate signal. TTL compatible. |
| 22 | RedPt | Red light pointer signal. TTL compatible. |
| 23 | EMSTOP | Emergency stop signal. TTL compatible. |
| 13,24,25 | Unconnected. |
| Pin | NAME | Function |
| 1 | XORG0 | The home signal of extension axis X. To use this pin just connect it and GND to a switch. In software In14 represents this pin. |
| 2 | GIN15 | General input in15, using GND as a reference ground. |
| 2, 10 | OUT4, OUT5 | General Output Out 4-Out 5, using GND as reference ground. They are all TTL output . |
| 4, 5 | Vin | Input pin for 5V power supply. |
| 11, 12, 13 | Gnd | Reference ground of 5V power supply |
| 14 | XDIR+ | Direction signal of extension axis X. It is a TTL output. For common anode, use VCC and XDIR+ signals, and VCC is anode signal. |
| 15 | XPUL+- | Pulse signal of extension axis X. It is a TTL output. For common anode, use VCC and XDIR+ signals, and VCC is anode signal. |
| 8 | ReMark | Repeat marking signal. Use GND as a reference ground, to use this signal just connect a switch between this pin and GND. When it is activated the control will mark the content in the cache. |
What inside?
Suppliers with verified business licenses
Audited Supplier 
){kind=link}
){kind=link}